Vista Imaging Vista Routing - Manual (Page 65)

Routing User Guide Using the Routing Gateway
7 Purge completed and expired entries in the Transmission Queue
Use this option to control the size of the transmission queue. Executing this option will
remove entries if both of the following conditions are met:
ƒ The status of the entry indicates that an image file has been transmitted successfully.
ƒ The entry is older than the
RETENTION PERIOD (number of days) for the applicable
destination.
This option should be run once a month as part of a Routing Gateway’s periodic
maintenance cycle.
8 Re-Queue all failed entries in the Transmission Queue
Use this option to try to re-send routed images that could not be sent within the number
of attempts specified for that destination.
This option should be run periodically as part of a Routing Gateway’s maintenance cycle.
Sites that route a large number of exams, or that route high priority exams, should run
this option daily. Sites that route a lower volume of exams may only need to run this
option once a week.
9 Remove obsolete entries from Transmission Queue
Use this option when there is a large backlog of outdated entries in the transmission
queue. When this option is executed, you will be prompted to enter a cutoff date (the date
can be entered using FileMan conventions). After the date is entered, all unprocessed
queue entries older than the specified date will be removed.
This option should be run once a month as part of a Routing Gateway’s periodic
maintenance cycle.
10 Display Current Set of Routing Rules
Use this option to display the current set of routing rules. This option is especially useful
immediately after using option 5 to import a new set of rules.
April 2006 VistA Imaging V. 3.0, Patch 18 57