Vista Imaging Vista Routing - Manual (Page 89)

Routing User Guide Appendix B: Using MAG_Decompressor
Note: If the DLL file is not present, contact the Imaging Group for information
about acquiring a toolkit license. The decompression software will not work
without the DLL file.
d Enter the following command to activate the program (The command will
complete without any warning or error messages).
Mag_Decompressor –install <Enter>
e Close the command window.
5 Activate the decompression service as follows:
a In the Control Panel, double-click Administrative Tools.
b Double-click Services. (On some versions of the Windows operating system, this
icon is labeled Component Services.)
c In the window that opens, locate the entry for the “MAG J2K Decompressor
Service”.
d Right-click on the entry and select Start. Wait until the status display shows that
the service is started.
e Right-click again on the entry and select Properties.
f In the Properties window, select Automatic as the startup type, then click OK.
g Verify that the status display shows that the service is “Automatic”.
h Close all remaining Control Panel windows.
Your system is now ready to start decompressing files that were routed in compressed
form.
Note: when parameters need to be modified, the steps listed above can be used to
establish new values for the parameters. However, it will be necessary to reboot the
computer before the new values of the parameters will become effective.
MAG_Decompressor Logging
The decompression software will run automatically when needed. If problems are
encountered review, the log files generated by the MAG_Decompressor software.
Log files are stored in the location specified in the DECOMP_LOG_FSPEC system
variable. The ten most recently generated log files are retained.
Sample log entry:
2005-04-19 16:59:01 -----------------------------------------------------------------------------------------------
April 2006 VistA Imaging V. 3.0, Patch 18 81