Vanguard Managed Solutions PRVYS18PWA - Manual (Page 14)

14 104343
UNVENTED PROPANE/LP GAS LOG HEATER
VANGUARD FLAME-MAX ®
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
For Vintage Oak Model
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Locate pegs on the bottom of back log
(#1). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 17).
2. Locate the notches on the back of the
front log (#2). Slide these notches over
the tabs of the grate base (see Figure 18).
3. Locate the notches in the bottom of the
crossover log (#3). Place the crossover
log on top of the back log and front log.
Make sure the notches of the crossover
log line up with rectangular knobs on
top of the back and front logs (see Fig-
ure 19).
4. Add lava rock around base of heater.
Figure 17 - Installing Back Log
Back Log
(#1)
Crossover
Log (#3)
Figure 19 - Installing Crossover Log
Figure 18 - Installing Front Log
Front
Log (#2)
Notch
Peg
Notch
Rectangular
Knob
Notch
Peg
Tabs of
Grate Base
Hole
Rectangular
Knob
For Golden Oak or Birch Models
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 20. Make sure
middle section at bottom of log set is
seated into “U”-shaped cutout in cen-
ter of chassis (see Figure 20).
Note: 36”
and birch models have more features
but fit on the chassis the same. Log will
fit securely on chassis.
IMPORTANT:
Make sure log does not cover any
burner parts.
2. Place lava rock around base of heater.
Figure 20 - Installing Golden Oak or
Birch One-Piece Log Set
Figure 21 - Installing Golden Oak or
Birch One-Piece Log Set (Top View)
One-Piece
Log Set
Middle
Section
at
Bottom
of Log
Set
Burner
“U”-shaped Cutout
in Chassis
Chassis
Burner
One-Piece
Log Set
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.