VocoPro CDG-X3P - Manual (Page 10)

9
Getting connected cont.
External speaker connection
You can connect directly to speakers using either MDP (banana plug) speaker cables or standard speaker wires.
Using MDP (Banana Plug) Speaker Cables
Be sure to correctly match the polarities (+/-). Please do not try to connect more than one speaker per channel, as
the load may exceed the amplifiers handling capacity, causing it to overload.
Using Standard Speaker Wire
Unscrew each plastic bind until you are able to see an interior hole for speaker wire (this is easier to locate when view-
ing from a side angle). Slide the speaker wires into the slots and tighten the plastic binds to tighten them in place. Be
sure there is no insulation on the speaker wire preventing conductivity.
OUT
RF Connection
Left Speaker Right Speaker