Vantec UGT-IS602R - Manual (Page 18)

Erasing RAID Configuration Data
Note: The RAID controller stores RAID configuration data on all
physical disks that are part of a virtual disk. RAID configuration data
must be erased on the physical disk before it can be used with another
virtual disk.
1. In the Topology pane, select Physical Disk (VD 0: Default > PD
0: ST3750330MS in Figure 14) and press Enter.
A menu pops-up, as shown Figure 14.
2. Select Delete to delete the virtual disk, as shown in Figure 14.
UGT‐IS602R Page 18
3. Select Yes when prompted to confirm the erase operation.