Vantec UGT-IS602R - Manual (Page 25)

UGT‐IS602R Page 25
To pause the rebuild process
1. In the Topology pane, scroll to the partially rebuild Virtual Disk.
2. Press Enter to view available operation on Virtual Disk.
3. Scroll to Resume and press Enter to resume the rebuild process.
Note: The rebuild process is both initiated and completed in the
BIOS. The Marvell RAID Utility (MRU), which runs in an OS
environment, cannot be used to either initiate, pause, resume, or
complete the rebuild process.
Deleting Virtual Disk
To delete a virtual disk
1. In the Topology pane, select Virtual Disk (VD 0: Default in
Figure 21) and press Enter.
A menu pops-up, as shown Figure 21.
2. Select Delete to delete the virtual disk, as shown in Figure 21.
3. Press Y to select Yes when prompted Do you want to delete this
virtual disk?
4. Press Y to select Yes when prompted Do you want to delete
MBR from this virtual disk?
Figure 21 Delete Virtual Disk