Hardware installation, Creating and managing virtual disks, Creating virtual disks – Vantec UGT-IS602R User Manual
Page 5
UGT‐IS602R Page 5
Hardware Installation
1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer’s cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the board, carefully align the card’s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5.
Attach your internal devices to the 2+1 SATA 6G & PATA PCI-E
COMBO HOST CARD WITH RAID.
6.
Replace the slot bracket’s holding screw to secure the card.
7.
Replace the computer cover and reconnect the power cord.
Creating and Managing Virtual Disks
Creating Virtual Disks
This section describes the produce for creating virtual disks using the
BIOS Configuration Wizard.
To create a virtual disk
1.
In the Topology pane, scroll to HBA0: Marvell 0 and press Enter
to select. A menu pops-up, as shown in Figure 1.
Select Configuration Wizard and press Enter to begin creating