Velocity Micro SEAL-IT 100 - Manual (Page 32)

Chapter 2: SEAL-IT 100
SEAL-IT 100 Device Driver User Guide
28
Workflow for configuring the SEAL-IT 100
About this topic This topic presents the workflow for configuring the SEAL-IT 100 device
driver.
Read this topic if you are an administrator responsible for setting up
devices in VWorks or BenchWorks.
Before you start Before you can configure the SEAL-IT 100 device driver you must have
installed it. For installation instructions, see “Setting the properties for a
device” on page 16.
Workflow
Related topics
Step Topic
1 “Adding devices” on page 10.
2 “Creating a SEAL-IT 100 profile” on page 29.
3 “Setting the properties for a device” on page 16.
For information about... See...
Device drivers “About device drivers” on page 7
Setting SEAL-IT 100 task
parameters
“Setting SEAL-IT 100 task parameters”
on page 31
Managing SEAL-IT 100 Profiles “Managing SEAL-IT 100 profiles” on
page 32
Using SEAL-IT 100 Diagnostics “Operating the SEAL-IT 100 with
diagnostics” on page 33