Velocity Micro SEAL-IT 100 - Manual (Page 35)

31 Chapter 2: SEAL-IT 100
SEAL-IT 100 Device Driver User Guide
Setting SEAL-IT 100 task parameters
About this topic When the SEAL-IT 100 is added to the device manager, the task
associated with the device becomes available in the protocol editor.
When a task is added to a protocol, you need to set the parameters for it.
This includes choosing the SEAL-IT 100 to use and what “Seal Plate”
properties to use.
This topic describes the tasks and their parameters.
Read this topic if you are:
❑
An administrator or technician responsible for creating protocols
❑
An operator who wants to make changes to the SEAL-IT 100 task
parameters in a protocol
Note: Operators cannot save changes to protocols.
About the Seal Plate
(SEAL-IT 100) task The SEAL-IT 100 device driver adds one task to VWorks or BenchWorks.
This task is used to seal a plate with cold adhesive film.
There is only one task associated with the SEAL-IT 100 and it is
represented by this icon in the Protocol Task toolbar:
The task is available in the protocol editor, but not the pre-protocol
editor or post-protocol editor.
Setting Seal Plate
(SEAL-IT 100) task
parameters To set the Seal Plate (ABgene SEAL-IT 100) task parameters:
1. Add the Seal Plate (ABgene SEAL-IT 100) task to a protocol process.
2. In the Protocol Task Parameters toolbar, make sure the Task Settings
tab is displayed.
3. Select the SEAL-IT 100 or SEAL-IT 100s and click Add.
The device name moves to the right of the Add and Remove buttons.
There are no Seal Plate properties to be set here. Properties used by the
task are set in the profile.