Viking F20518A - Manual (Page 11)

21
1
Note: Refer to “Electrical & Gas
Requirements” section for proper
installation information.
Connect gas and electrical. Before placing appliance in
operation, always check for gas leaks. This must be
performed by your dealer, a qualified licensed plumber,
or gas service company.
Connecting Gas & Electrical (36”W.)
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify your appliance has been
properly grounded in accordance with
local codes or in absence of codes, with
the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
20
1
2
2
20°
1
2
Open door approximately 20°, then slowly pull upward
until the door stop pops out of door socket.
Gently close until the door rests against one of the stop
notches.
3
Slide door completely from hinge arms.
Door Removal (36”W.)
NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
Installation (36”W.)
CAUTION
To avoid risk of personal injury or property
damage, verify door stops are engaged
before removing door.