Viking F20518A - Manual (Page 12)

23
1 2
2
1
3
3
2
1
3
4
1
2
5 6
Final Installation (36”W. Double)
Install upper oven as described on page 21, “Final
Installation” (36”W. single).
Place bottom oven on a protected area near the
cabinet. Remove 2” hole knockout from oven top.
Remove access panel from oven side and
pipe plug from pipe tee.
Attach male connector to pipe tee. Feed flex tubing
through 2” hole and attach to the male connector.
Replace access panel. Push lower oven straight into cabinet.
Note: Purchase necessary gas kit – IKD-VGSO.
22
1 2
3 4
5 6
Final Installation (36”W. Single)
Lift oven into position. Push oven straight into cabinet.
Remove all knobs, push buttons, and bezels on the
right control panel.
Remove lower access panel, side trim, and
control panel.
Insert four wood screws, (included with the oven),
through the cabinet side flange into the cabinet.
Replace lower access panel, side trim, and
control panel.