Operating heater, Continued, Manual lighting procedure – Vanguard Heating VN18A User Manual

Page 15

Advertising
background image

www.desatech.com

15

113052-01A

TO SELECT

HEATING LEVEL

WARNING: When running

heater, set control knob at LOW,
MEDIUM, or HIGH locked posi-
tions. Never set control knob
between locked positions. Poor
combustion and higher levels
of carbon monoxide may result.

CAUTION: Do not try to ad-

just heating levels by using the
equipment shutoff valve.

Slightly press in control knob and turn coun-
terclockwise

to the LOW, MED, or HI

positions (see Figure 21).

IMPORTANT:

Release downward pressure

while turning control knob. Control knob will
lock at the desired position.

OPERATING HEATER

Continued

OFF

PILO

T

LOW

MED

H

I

OFF

PILOT

LOW

MED

H

I

OFF

PI

LO

T

LO

W

M

ED

HI

OFF

PILO

T

LO

W

MED

HI

LOW

HI

OFF

MED

Control

VN18A

VN30A

Knob

VP16A

VP26A

Figure 21 - Burner Patterns for Non-

Thermostat Models

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1.

Turn control knob clockwise

to the

OFF position.

2.

Turn off all electric power to the appliance
if service is to be performed.

Shutting Off Burner Only (pilot stays lit)

Turn control knob clockwise

to the

PILOT position.

MANUAL LIGHTING

PROCEDURE

1.

Remove front panel (see Figure 7, page 8).

2.

Follow steps 1 through 5 under Lighting In-
structions
, page 14.

3.

With control knob pressed in, strike match.
Hold match to pilot until pilot lights.

4.

Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 8,
under Lighting Instructions
, page 14.

5.

Replace front panel.

THERMOSTAT MODELS

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,
follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier from

a neighbor’s phone. Follow the gas
supplier’s instructions.

• If you cannot reach your gas supplier, call

the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the
knob will not push in or turn by hand, don’t
try to repair it, call a qualified service tech-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.

D. Do not use this appliance if any part has been

under water. Immediately call a qualified ser-
vice technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.

Advertising
This manual is related to the following products: