Veo Pan and Tilt - Manual (Page 12)

Network Camera User’s Guide
12/95
Alarm I/O Connector
The Network Camera provides a terminal block with 8 pins of connectors located on the
center of the back panel. There are 3 pins for two alarm inputs and 5 pins are for alarm
output. The I/O connectors are physical interface to sense and/or activate alarm signals
to a variety of external sensors or alarms. Please refer to the Appendix B in this manual
for more information.
CF Card Socket
The CF card socket is located on the right side of the back panel of the Network Camera.
User can plug a CF memory card into this socket to store the alarm or scheduled images.
This is very useful to keep the evidence of alarms or scheduled images for reference.
Factory Default Reset
This button is hidden in the pinhole above the Alarm I/O connector. Please refer to the
Appendix A in this manual for more information.
Microphone
The Network Camera’s has built-in an internal microphone. This microphone is also
hidden in the pinhole above the Alarm I/O connector.
Status and 10/100M Ethernet LEDs
LED stands for Light-Emitting Diode. The Status and Ethernet LEDs are located on the
right side of the back panel of the Network Camera. The Status LED will turn orange
while system is booting up successfully.
Ethernet LED is used to indicate the status of Network connection. While not any
connection to the Network Camera, the LED will be off and flash orange while some one
access this Network Camera.