Appendix d: ping ip address – Veo Pan and Tilt User Manual
Page 85
Network Camera User’s Guide
85/95
Appendix D: PING IP Address
The PING (stands for Packet Internet Groper) command is used to detect whether a
specific IP address is accessible by sending a packet to the specific address and waiting
for a reply. It’s also a very useful tool to confirm Network Camera installed or if the IP
address conflicts with any other devices over the network.
If you want to make sure the IP address of Network Camera, utilize the PING command
as follows:
z
Start a DOS window.
z
Type ping x.x.x.x, where x.x.x.x is the IP address of the Network Camera.
The replies, as illustrated below, will provide an explanation to the problem.
If you want to detect any other devices conflicts with the IP address of Network Camera,
also can utilize the PING command but you must disconnect the Network Camera from
the network first.