Veo Pan and Tilt - Manual (Page 76)

Network Camera User’s Guide
76/95
Appendix A: Restore Factory
Default Settings
There is a button hidden in the pinhole above the Alarm I/O connector. It is used to
restore the factory default settings. Sometimes restarting the Network Camera will make
the system back to a normal state. If the system still got problems after reset, user can
restore the factory default settings and install it again.
Restore the Network Camera:
1. Power off the Network Camera.
2. Insert the paper clip or other tool and press and hold the button down
continuously.
3. Power on the Network Camera again.
4. Wait at least 8 seconds and release the tool. Then the Network Camera has
been restored to default settings.
5.
Note: Restoring the factory default setting will lose the all previous settings forever. User
needs to run the IP Finder program to search the Network Camera and configure it to let
the Network Camera work properly again.