Veo Pan and Tilt - Manual (Page 29)

Network Camera User’s Guide
29/95
Default: System default value.
Note: The value on the list box display the current setting of the current image, when
you make a new selection, the value on the list box will be changed until you save the
new setting.
Image, Mirror, Focus Mode, White Balance Mode, Exposure Mode:
These functions are available for PTZ Network Camera and Video Server only. It’s not
functional for this model.
Saturation, Sharpness, Contrast, Hue:
To control the camera parameters, key in these values respectively.
Audio:
PCM and ADPCM could be selected as compression method of audio. Normally,
ADPCM could generate smaller size of audio data rate.
Camera Tour:
Tour Name: The group name of the sequence of camera tour
Dwelling Time: The time period between every tour point.
Sequence: 16 points can be assigned. The tour point will also show the location name if
you had entered the location name while preset the camera.
Enable: Which sequence group should be activated.
To use the camera tour function, user must preset some camera positions first. The
maximum number of preset points is16.
In the Camera Tour page, choose the one tour name from A to E. Fill the dwelling time
and tour sequence by preset points, and then save these setting. You can repeat above
procedure to set more camera tours.