Vizio VP503 - Manual (Page 12)

VIZIO ® VP503 HDTV10A User Manual
Version 5/27/2008 12
www.VIZIO.com
1.5 1.5 1.5 1.5 VIZIO Remote Control VIZIO Remote Control VIZIO Remote Control VIZIO Remote Control
GUIDE – This button displays program information. Press this button once and the information of the
program being viewed is shown. Press it a second time and the Electronic Programming Guide will
appear in the screen.
POWER ( ) – Press this button to turn the TV on from the Standby mode. Press it again to return to
the Standby mode.
TV – Press this button to select TV.
AV – Press this button to select the Audio Video input. Pressing this button repeatedly will get you to the
AV input. Keep in mind that if S-Video cable is being used, then AV will show the signal going through this
input as the S-video takes priority.
COMPONENT – Press this button to select the Component (YPbPr) input.
HDMI – Press this button to select the HDMI input. Pressing this button
repeatedly will get you through the HDMI (HDMI 1, HDMI 2, HDMI 3 and
HDMI 4) different inputs.
MENU – Use this button for the On-Screen Display (OSD) menus. When
use within the OSD menus, pressing this key will make the selection of an
option.
▲▼◄► - These buttons navigate the On-Screen Display (OSD).
MUTE – This button turns the sound on and off.
LAST – This button recalls the previously viewed channel when it is used in
TV mode; meaning that the TV unit has control over the signal or program
being watched. This button also has different functions when being used in
conjunction with the On-Screen Display (OSD)
menu.
VOL ( ▲ ▲ ▲ ▲ or ▼ ▼ ▼ ▼) – These buttons turn the volume
up or down.
CH ( ▲ ▲ ▲ ▲ or ▼ ▼ ▼ ▼) – These buttons change the
channels up or down.
PIP - Pressing this key will make the picture-in
picture feature to be activated. Pressing it again
will display the POP option. Pressing it again will
disable PIP/POP.
SWAP – Press this button to swap between
small and big screens when in PIP mode.
FREEZE – Press it to freeze the main screen
display.
NUMBER BUTTON PAD – Use these buttons to
select a channel or enter a password.
INPUT – This button allows the user to cycle
through the inputs. Repeatedly pressing of this button will step you through
the input sources in the following sequence: TV, AV (AV/S-VIDEO),
Component, RGB, HDMI 1, HDMI 2, HDMI 3 and HDMI 4. Once you have
stepped through the entire sequence, you will return to the beginning.
- (DASH) – When selecting a digital channel directly; use this button for the separation of main and sub-
channels. For example, channel 28-2 would be selected by the button sequence 2 8 - 2.