Setting up your scanner to work with paperport – Visioneer XP220 User Manual
Page 136
S
ETTING
U
P
Y
OUR
S
CANNER
TO
W
ORK
WITH
P
APER
P
ORT
129
S
ETTING
U
P
Y
OUR
S
CANNER
TO
W
ORK
WITH
P
APER
P
ORT
On the PaperPort Scan Pane, when you selected a scanner from the
Available Scanners window, the Scan button at the bottom of the
panel should become active after approximately 5 to 10 seconds. If it
doesn’t, you need to set up your scanner to work with PaperPort.
Note: Setting up your scanner is a one-time-only process for each
option listed in the Available Scanners window. Therefore, you may
have to set up your scanner once each for TWAIN: Visioneer Strobe
XP 220 and WIA: Visioneer Strobe XP 220. The setup process is the
same for each option. You will not have to set up the scanner again
unless you uninstall the scanner and PaperPort software, then re-install
them.
If this Scan button is not active, you need to
set up your scanner to access PaperPort.