Visioneer XP220 - Manual (Page 19)

12 V ISIONEER S TROBE XP 220 S CANNER U SER ’ S G UIDE
S
TEP
2: C
ONNECT THE
P
OWER
S
UPPLY AND
USB C
ABLE
You may now connect the scanner’s power supply and USB cable. The
USB cable plugs into any available USB port on the computer. Check
your computer’s manual for USB port locations.
Attach a Plug Adapter to the Power Supply
1. You received three plug adapters with your scanner. Use the correct
adapter for the electrical wall outlet at your location.
The three plug adapters are for:
2. Position the adapter so it aligns with the edges of the power supply
and will slide onto the post in the middle of the two contacts.
Gently slide the adapter forward until it snaps into place.
Note: You can connect the scanner to your computer while the
computer is running. You do not have to shut down your computer.
Note: Remember to take the plug adapters with you when traveling
to countries with different electrical outlets. To remove an adapter, see
the section, “How to Replace the Plug Adapter” on page 151.
United States United Kingdom Europe