Visioneer 9650 - Manual (Page 12)

B EFORE Y OU B EGIN 5
Installing
Installation is a quick, four-step process:
1. Assemble the scanner
2. Install the software
3. Connect the power supply
4. Connect the USB cable and turn on the power
B
EFORE
Y
OU
B
EGIN
Please make sure of the following before you begin installation:
■ If your computer has AntiVirus or AntiSpyware software running,
you may encounter alerts or messages during installation asking
you to allow the installation to proceed. Although the messages will
differ based on the software your computer is running, in each case
you should allow the installation to proceed if that option is
available. Alternatively, you can turn off the AntiVirus or
AntiSpyware software before installing your scanner. But if you do,
make sure to turn it back on again when installation is finished.
■ If you already have a scanner connected to your computer, you may
need to remove its driver programs first before beginning the
installation of your Visioneer 9650 USB scanner. Please see “How
to Uninstall Your Scanner” on page 143 for basic instructions, or
see the User’s Guide that you received with your other scanner.
Warning: Do not plug in the USB cable until after you have
installed the software. Complete the installation steps in the order
described in the installation procedure below.