Visioneer 9650 - Manual (Page 148)

T ROUBLESHOOTING 141
Problem: During installation I got the error message: PaperPort
Installation is not complete. What do I do?
The installation procedure was not successful. You need to reinstall the
PaperPort software.
Problem: I got the error message: PaperPort cannot allocate enough
memory to perform internal critical operations. What do I do?
Close any other active applications so that additional memory is
available. If you click Continue, PaperPort moves the file to the
PaperPort data directory and renames the file with the prefix “bad.”
This allows you to recover the file later.
To recover the file, you can import it into PaperPort by using the Import
command in the File menu.
Problem: If the USB cable is disconnected during a scan, the
scanner does not reconnect when the USB cable is plugged back in.
• Unplug the power cable from the scanner, and then plug it back in.
• If the scanner does not reconnect:
1. Unplug the power cable from the scanner.
2. Restart your computer.
3. After the restart is complete, plug the power cable back in.
Problem: The installation will not complete successfully. If
installation finishes, the scanner’s OneTouch 4.0 options do not
seem to work properly. What do I do?
A likely cause is that some driver programs are already installed on your
computer for another scanner. They are interfering with the installation
and OneTouch options, and you need to remove those other drivers and
re-install your Visioneer 9650 scanner. Please see the documentation
that you received with the other scanner for the steps to remove its
driver programs. You can also use the basic steps in the section “To
Install Another Driver” on page 144, but instead of uninstalling
OneTouch 4.0, uninstall the other scanner’s driver programs. After
uninstalling the other scanner’s driver programs, uninstall OneTouch
4.0 using the steps on page 143, then reinstall it using the steps starting
on page 9.