VTech I6785 - Manual (Page 7)

www vtechphones com 7
G
ett
in
g s
ta
rte
d
• Plug the AC adaptor
into an electrical outlet
If the battery has not
been charged,
place the handset in the
base or charger, and
allow it to charge for at
least 16 hours
• Caution: Use only
the VTech power
supply provided with
your phone •
If the phone will not be
used for a long period of
time, remove the battery
to prevent possible
leakage
• If you have any trouble
installing your phone,
please refer to the
Troubleshooting
section near the end of
this manual
• When in low battery
mode, the keypad
sounds, backlighting
and speakerphone
features will not work
When the battery has
been charged, these
features will return to
their normal function
Installation
Check battery indicator
If you receive a check battery warning, it indicates one of the following:
1 There is no battery in your handset You need to install the supplied battery into your handset (see
Install handset battery on page 5 )
2 The battery needs to be replaced
3 The battery has been installed incorrectly Please reinstall (see
Install handset battery) and/or
see the diagram in the battery compartment of the handset
Check for dial tone
After the battery is charged, press or SPEAKER on the handset You should hear a dial tone
If not, see Troubleshooting