Vision Fitness E3800HRT - Manual (Page 33)

29
GENERAL
USING FACILITY ENGINEERING MODE SETTINGS
Engineering mode is used to customize your Bike for your facilities needs,
or to view useful information about your Bike. These features are only
accessible to your staff when they press the keys in a specific sequence.
USING ENGINEERING MODE
You must supply power to the Bike by turning the pedals.
• To enter press and hold the UP and DOWN arrow keys
simultaneously for four seconds or until you see the message
• When in engineering mode you can scroll through the optional
settings by using the UP and DOWN arrow keys. Press the ENTER
key to select the setting you wish to view or modify.
• Use the UP and DOWN arrow keys to modify the settings.
• Press the ENTER key to save your setting.
• Press and hold the PAUSE key for four seconds to exit engineering mode.
The following settings will be available in the engineering mode:
MAXIMUM TIME –
The manager has the ability to set the maximum time
the workouts can be set for. This feature is necessary for busy facilities
that may want to limit the amount of time their users are on the Bike.
The default is 99 minutes.
USER DEFAULT TIME –
This mode allows you to set a specific default time
for setup mode. This default time will also be used when the exerciser
presses START for a quick start program.
USER DEFAULT AGE –
This mode allows you to set a specific default age
for setup mode. This is particularly useful when the Bike is placed at
a facility where the user’s age range is very specific, such as a school.
This default age will also be used when the exerciser presses START
for a quick start program.
USER DEFAULT WEIGHT –
This mode allows you to set a specific default
weight for setup mode. This default weight will also be used when the
exerciser presses START for a quick start program.