Vita Spa xStreamPro - Manual (Page 13)

3s
TO START
SELF TEST
TO CANCEL
SELF TEST
continues
on next
page
Turns filtration On/Off
on shown hour.
12: - Off
12: F Filtering
Cycles up through
filtration hours
USE ARROWS
TO CHANGE
BETWEEN
MODES
FACTORY DEFAULTS
12: - AM 12: - PM
1: - 1: -
2: - 2: -
3: - 3: -
4: - 4: F
5: - 5: F
6: - 6: -
7: - 7: -
8: F 8: -
9: F 9: -
10: - 10: -
11: - 11: -
THERAPY PROGRAMMING INSTRUCTIONS
REFER TO PROGRAMMING INSTRUCTIONS ON PAGE 21 FOR QUICK PROGRAMMING STEPS
A. PROGRAMMING MENU .....................................................
Note: All programming functions are shown sequentially. To access any
specific programming step, you have to enter programming from the
beginning, as explained here.
Press and hold for three (3) seconds until “dISC” is on the screen to
enter the programming menu.
To exit programming mode, press , or at any point in the
sequence or wait for 10 seconds (without pressing any button).
B. SELF - DIAGNOSTIC TOOL ...............................................
Note: This feature is operational on all Control Boards Rev J and up.
Your spa controller offers the latest state-of-the-art diagnostic tool. To start
the test, press
while the display is showing "diSC". This test will run the
equipment sequentially for two (2) minutes. To cancel the self-test at any
time, press
. Once the test is completed, the message "good" will be
displayed if your spa operates properly. If a problem is found, the malfunction
code will be displayed. Please contact your dealer for corrective action.
C. HEATING ..........................................................................
Your spa is pre-programmed from factory to run on AutoHeat mode every day
of the week. That means whenever the temperature of the water falls 1ºF
(0.5ºC) below the set temperature, the ICS
TM control will start the heating cycle
and run it until the temperature reaches 1ºF (0.5ºC) above the set temperature.
Note: Refer to Section E. HEAT DAYS & TEMPERATURE for how to change this setting.
To save even more, you may switch it to ECONOMY mode, where the heating cycle
will only come on during programmed filtration hours. (See “Filtration Cycle” below).
Note: In ECONOMY mode, if at the end of filtration cycle the water has not reached the
set temperature, the heating cycle will stop. This mode is used for energy conservation,
the same way you would control your heat or air conditioning in your house.
D. FILTRATION CYCLE ..........................................................
Your spa is pre-programmed from the factory to run the filtration cycle for
two hours in the morning and two hours in the evening. It is recommended
that filtration hours be set to the minimum necessary to maintain water
quality.
Notes: Please review this setting upon installation.
Some Control Boards programmed for AH may jump the filtration hours
setting. If that happens, change from AH to ECO, program the desired filtration
hours and change back to AH.
During filtration, the water temperature may rise slightly, therefore
to prevent overheating during the warmer months of the year, do not
program filtration for more than 6 hours a day (4 hours in very hot
climates).
Keeping your set temperature a few degrees below your desired
temperature will aid in controlling water temperature.
PAGE 7