Vita Spa xStreamPro - Manual (Page 20)

12/24
HOUR
MINUTES
MONTH
DAY
YEAR
continues on next page
GOES BACK
TO THE
BEGINNING
USE ARROWS TO CHANGE
± TO LOCK
² TO UNLOCK
± TO LOCK
² TO UNLOCK
SWIM PROGRAMMING INSTRUCTIONS
E. CLOCK AND CALENDAR SETTING ......................................
The display will sequence through the time and calender settings as is
pressed.
Sequence is: “H=12” – 12-hr or “H=24” – 24-hr clock
Hours setting
Minutes setting
Month setting
Day setting
Year setting
Use and to change blinking digits.
F. HEAT LOCK .......................................................................
The ICS TM controller allows you to prevent anyone from changing the water
temperature you have chosen, while still allowing the use of any of the spa
functions. While the display shows “HL” Heater Lock position. Press
for
to Lock in the set temperature. Notice the lock icon ± solid on the display.
No temperature changes are allowed.
Press to remove the “Heat Lock” of the heater. Notice that the lock icon
will disappear. All spa functions, including temperature adjustment will be
accessible.
G. PANEL LOCK .....................................................................
The ICS TM controller also allows you to lock the spa Control Center to keep
children or others from using any of the spa functions.
To block all buttons, while the display shows “PL” press . Notice the
flashing lock icon ± on the display indicating the Control Center is locked.
To unlock the Control Center, press again. “PL” will display, press .
The flashing lock icon will disappear and all spa functions will be accessible.
H. DISPLAY ...........................................................................
The Control Center display can be inverted to allow easier reading from inside
the spa. While the display shows “FLIP”, press
or to invert the
display back and forth.
I. ADVANCED FEATURES SETUP............................................
Refer to the ADVANCED FEATURES SETUP section.
To exit programming mode at any point in the sequence, press any button
other than
, or , or wait for 10 seconds (without pressing any
button).
PAGE 14