Vidikron VERSION 50 - Manual (Page 29)

29 Vidikron Vision Model 50 Owner’s Operating Manual
Basic Operation
• Press ZOOM and the arrow buttons ( ◄/►)
to adjust the projected image size.
• Press FOCUS and the arrow buttons ( ◄/►)
to focus the image.
• Press LENS SHIFT and the arrow buttons
(
▲/▼) to adjust the lens vertically.
Adjusting the Zoom,
Focus and Lens Shift
Adjusting Projector
Height or Projection
Angle
L-BOX
I-WIDE CINEMA C-FILL
MEM1
ISF
NT
ISF
DAY
DEF
ON OFF
COMP 1
COMP 2
S-VID VIDEO
RGB HD HDMI
ANA 4X3
Turning on the Power
• Turn on the main power switch on the rear
of the projector. The POWER LED will light
orange.
• Press the ON button on the remote control
to turn on the projector. The POWER LED
flashes orange during the warm up period,
then lights solid green.
• “Searching….” appears on the screen before
the projector identifies the input signal,
and remains there until a valid signal is
detected.
• If an incompatible input signal exceeds
the range of the projector, a “No signal
supported” message appears on the screen.
This message remains on the screen until
you change the input signal.
• To adjust the projector height or projection
angle, or to compensate for a mounting
surface that isn’t level, turn the four
adjustable feet on the bottom of the
projector.