Vidikron VERSION 50 - Manual (Page 40)

40 Vidikron Vision Model 50 Owner’s Operating Manual
On-Screen Display Menus
Installation Vision Model 50
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
Language 
Picture Configuration 
Keystone 
Installation
Language
Picture Configuration
Keystone
OSD Position
OSD Timer
PIP/PBP Setup
Background Color
To access the Installation menu, press MENU, then press the ▲ or ▼ arrows to highlight
Installation and press ENTER. The Installation sub-menu will then appear (see above).
Press EXIT to return to the previous menu or press MENU to close all menus.
NOTE: When you change a setting in the Installation menu, the change takes effect immediately;
you do not need to press
ENTER afterwards. (Press EXIT to return to the previous menu or MENU
to exit.)
Press the ▲ or ▼ arrows to select from the available Languages: English, French, Spanish,
German and Italian.
Press the ▲ or ▼ arrows to select the projector’s Picture Configuration. The projector
can be installed on a ceiling or in a rear-screen configuration with one or more mirrors.
There are four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.
To correct distortion resulting from the angle of the projection, select Keystone and use
the
◄ or ► arrows to make the image rectangular.
NOTE: Vidikron recommends that the keystone feature not be used unless absolutely necessary, as
it may cause artifacts in the image.
Press the ◄ or ► arrows to adjust the horizontal and vertical position of the OSD.
Press the ◄ or ► arrows to set the OSD Timer. This timer controls how long the menus
remain on-screen after selecting them. Select from 0 to 60 seconds, in 3-second increments.
When you set the OSD to 0, the menus remain on-screen until you hide them by pressing
MENU.
OSD Timer 
OSD Position 