Vidikron VERSION 50 - Manual (Page 36)

36 Vidikron Vision Model 50 Owner’s Operating Manual
Image Options Vision Model 50
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
Active Image Area
Active
Image Area
Active Image Area
Image Option
Input Select
Aspect Ratio
SD Enhance
Video Filter
HD/RGB Adjust
Blue Enable
Save Settings
Load Saved Settings
To access additional image settings, press MENU, then press the ▲ or ▼ arrows to highlight
Image Option and press ENTER. The Image Option sub-menu then appears (see above).
To select a source signal, highlight Input Select, press ENTER and select Video, S-Video,
Component 1, Component 2, RGB-HD or HDMI. Then, press ENTER to confirm.
To change the aspect ratio (size and shape) of the projected image, select Aspect Ratio
from the Image Option menu and press ENTER. There are six aspect ratios available that
can be selected for video signal inputs:
On-Screen Display Menus
Input Select 
Aspect Ratio 
• Anamorphic
The image is compressed vertically,
but anamorphic software will appear
properly proportioned. This is best
suited for use with 16:9 DVDs and HDTV
programming.
• Standard (4/3)
The input signal is scaled to fit in the
center of the 16:9 screen.
• Letterbox
The image in the Letterbox mode is
stretched vertically, and the top and bottom
portion ‘blanked off’. This ratio is best suited
for LaserDisc movies or non-anamorphic
DVDs.
• IntelliWide
A 4:3 image is transformed into a 16x9
image.