Vision Fitness Multi-Station Gym ST710 - Manual (Page 13)

13
3
STEP
• Place weight stack bumpers (Q05) over
the holes of both weight stack support
blocks (AK3). Place the guide rods over
and through the rubber weight plate
bumpers into the weight stack support
block. Use caution when adding the
weight plates. Don’t let the guides tilt too
far forward during installation. Slide each
of the 20 weight plates over both sets of
the guide rods on top of one another.
Place the header weight plate over both
sets of guide rods on top of other weight
plates. NOTE: Place the header plate
with the pulley bracket on the leg
press side weight stack! The header
plate without the pulley bracket will
go on press arm side.
• Slide a stopper ring (K18) on the left
guide rod of the leg press side and tighten
the set screw so the bottom edge of the
ring is nine inches from the top of the rod.
• Rest each guide rod behind the top
bracket on the main center upright (AB1).
WEIGHT STACK
Q05
Q05
AK3
AB1
AK3
K18