Vision Fitness Multi-Station Gym ST710 - Manual (Page 25)

15
STEP
25
• Slide a large disc onto extension of
knee pad post (AH1). Slide a round pad
onto the extension, followed by a small
disc. Secure with a bolt (M8x20) and a
flat washer (8.4x15x1.6). Repeat this
process to attach pads to other extension on
knee pad post, and extensions on leg curl
post (AH2).
• Secure seat back (J10) and seat bottom
(J11) on press arm seat back support (AJ3)
and press arm seat bottom post (AJ4) by
using eight bolts provided (M10x25).
• Slide a round pad (J12) on each
extension of the leg press seat back
assembly (AJ7 & AJ8). Secure pads with a
disc, a bolt (M8x20), and a flat washer
(8.4x15x1.6). Attach seat back (J15) and
seat bottom (J11) on leg press seat back
support (AJ7) and leg press seat bottom
support (AT1) using eight bolts (M10x25).
NOTE: Check to make sure the press
arm, functional arm, and leg press/lat
pulldown cables are taught. If tightened
properly, there should be no more than
1” of play between the beginning of
an exercise and the movement of the
weight plates. If there is more play
than this, thread one or more connection
p o i n t s f u r t h e r. T h e c a b l e s a r e t o o
tight if the weight selector pin can’t
easily be inserted. If this is the case,
back off the bolts at one or more of
the connection points, until the pin can
be easily inserted.
LIGHT BLUE BAG
AH2
AH1
AJ3
J10
J12
Small Discs
Large Discs
J12
AJ4
J11
J12
J11
J15
AT1
AJ7
AJ8