Vision Fitness Multi-Station Gym ST710 - Manual (Page 16)

16
AD1
AD2
AB3
AJ1
AC1 AC3
AJ6
AB5
AT1
AB4
6
STEP
• Attach the press arm swing arm (AD2) to
the press arm overhead tube (AB3) using
one of the axles provided. Center the shaft
in the connection and secure with a sleeve
(lining the flat surface up with the flat inside
of swing arm), a bolt (M12x25), a flat
washer (12x26x2), and a lock washer
(12.2x21x2.5). See diagram for clarification.
• Using the same method as the previous
step, secure the press arm (AD1) to the press
arm swing arm (AD2) using remaining axle
provided. The handles on the press arm
should be angled away from the weight
stack. Thread a pull pin (B) into the swing
arm until secured in one of the range of
motion holes in press arm.
• Attach the press arm seat back post bracket
(AJ1) to the press arm upright using two bolts
(M10x62), four flat washers (10.2x22x2),
and two nylon nuts (M10). Thread pull pin
(A) into bracket. Repeat this process for the
leg press seat back post bracket (AJ6) on leg
press upright(AB4).
• Attach the leg press seat bottom support
(AT1) to the leg press floor support (AC3)
and leg press upright (AB4). Use four bolts
(M10x62), eight flat washers (10.2x22x2),
and four nylon nuts (M10) to secure both
connection points.
• Thread two pull pins (A) into the press arm
floor support (AC1).
• Tighten all hardware.
BLACK BAG