Vidikron 140/150 - Manual (Page 39)

Installation
Vision Model 140/150 Owner’s Operating Manual 27
PRE
L
IMINAR
Y
3.5
Installing the Optional
CineWide Lens Mount If you are installing a Vision 140/150 with the optional CineWide or CineWide with
AutoScope system, proceed as follows to install the anamorphic lens mounting assembly
(stationary base plate or AutoScope lens motor).
Remove Projector Front Feet
(CineWide with AutoScope) (Skip this step if you are installing a fixed CineWide anamorphic lens.)
Place the projector upside down on a blanket or other soft surface. Loosen and remove the
two front feet on the projector.
Install Anamorphic Lens
Motor (CineWide with
AutoScope) or Base Plate
(fixed CineWide)
CineWide with AutoScope: Line up the eight
mounting holes on the lens motor housing
with those on the bottom of the projector.
Secure the motor to the projector with the
eight screws provided for this purpose.
Fixed CineWide: Line up the seven mounting
holes on the lens mount base plate with those
on the bottom of the projector, directly below
the primary lens. Secure the base plate to the
projector with the screws provided for this
purpose.
1. Do not install the CineWide lens yet, only the mounting plate or lens
motor. You will install the CineWide lens after you install the projector
and adjust the primary lens.
2. Some of the following steps are necessary only for CineWide with
AutoScope installations.
Note
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies are
both fully assembled.
Note