Vidikron 140/150 - Manual (Page 40)

Installation
28 Vision Model 140/150 Owner’s Operating Manual
PRE
L
IMINAR
Y
Install Projector Stand
(CineWide with AutoScope,
Floor-Mount)
(Skip this step if you are installing a fixed CineWide anamorphic lens, or
ceiling-mounting an AutoScope-equipped projector.)
If you are installing the Vision 140/150 in an upright position (not ceiling-mounted), use the
supplied hardware to attach the projector stand to the bottom of the projector as shown
below. This stand allows the projector to lie flat on the mounting surface with the AutoScope
lens motor installed.
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
➤
AutoScope stand used
for floor-mounted
projector