WHP Wireless WHP-1100 - Manual (Page 39)

Click Apply IEEE 802.1X Settings button to turn on 802.1x support on the AP
immediately without reset. Once this is done, normal traffic will not be forwarded
without authentication.
Config Window – Trap Server Panel
When the Outdoor AP is powered on, or an Ethernet port becomes active, an event
log will be generated indicating the time, the IP address of the reporting Outdoor AP,
and the event. You can view and save the event logs from the station as a Trap
Server.
To assign a trap server, click Trap Server (Figure 22).
Figure 22. Config window — Trap Server panel
Assign a station as a trap server by entering its IP address. Right-click on a blank in
the list and click Edit address.
To remove a trap server from the list, highlight it and click Clear address. Click
Clear all address to remove all assigned trap servers from the list (Figure 23).
Outdoor Access Point 33