Weider WESY96310 - Manual (Page 10)

10
12. Press a 1” Round Inner Cap (49) into one of the
Press Arms (46). Press a 1 3/4” Square Inner
Cap (44) into the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16” x 2 1/2” Bolts
(22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
13. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm.
Arm identification is very important for
step 14.
Attach a “V”-Pulley (50) and a Long Cable Trap
(31) to the Right Arm (48) with a 3/8” x 2 1/2” Bolt
(86) and a 3/8” Nylon Locknut (21).
Do not tight-
en the Nylon Locknut yet.
Attach a “V”-Pulley (50) and a Long Cable Trap
(31) to the Left Arm (47) in the same manner.
14. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle on the
Top Frame (55).
Note: Be careful not to con-
fuse the Right Arm with the Left Arm (47);
refer to step 13 to identify the Right Arm. Be
sure that the upper end of the Right Arm is
behind the indicated bracket on the Top
Frame.
Tap two 1” Retainers (69) and a 1” Round Cover
Cap (70) onto the axle on the Top Frame (55).
Be
sure that the teeth on the Retainers bend
toward the Round Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press two 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the lower end of each Arm with soapy water.
Slide a 10” Pad (45) onto the lower end of each
Arm.
12
13 86
31
31
50
50
21
Welded
Brackets
48
47
44
49
46
46
17
22
3
55
Bracket
Lubricate
Axle
47
69
70
44
45
44
14
69
70
Axle
45
48