Weider WESY96310 - Manual (Page 12)

12
18. Wrap the High Cable (58) around a “V”-Pulley
(50). Attach the Pulley and a Long Cable Trap
(31) to the indicated bracket on the Front Upright
(42) with a 3/8” x 2 1/2” Bolt (86) and a 3/8” Nylon
Locknut (21).
Be sure that the Long Cable Trap
is positioned to hold the Cable in place.
19. Route the High Cable (58) around the “V”-Pulley
(50) on the Left Arm (47). Be sure that the Cable
is in the groove of the Pulley and that the
Long Cable Trap (31) is positioned to hold the
Cable in place. Tighten the 3/8” x 2 1/2” Bolt (86)
and the 3/8” Nylon Locknut (not shown).
20. Route the High Cable (58) around the “V”-Pulley
(50) on the Right Arm (48). Be sure that the
Cable is in the groove of the Pulley and that
the Long Cable Trap (31) is turned to hold the
Cable in place. Tighten the 3/8” x 2 1/2” Bolt (86)
and the 3/8” Nylon Locknut (not shown).
21. Attach the Pulley Bracket (20) to the Top Frame
(55) with the 5/16” x 5” Bolt (68) and a 5/16”
Nylon Locknut (3).
Do not overtighten the
Nylon Locknut; the Pulley Bracket must be
able to move freely.
See the inset drawing. Route the High Cable (58)
around the 3 1/2” Pulley (15) attached to the
Pulley Bracket (20). Tighten the 3/8” x 2” Bolt (12)
and a 3/8” Nylon Locknut (not shown).
Be sure
that the Cable is in the groove of the Pulley
and that the Cable Trap (66) is turned to hold
the Cable in place.
21
18
86
86
31
31
50
50
21
58
58
19
20
42
47
86
31
50
58
20
68
3
55
48
Bracket
58
15
66
12