Weider WESY96310 User Manual
Page 13
13
22. See the inset drawing. Attach a 3 1/2” Pulley (15)
and a Cable Trap (66) to the upper hole in a Long
“U”-Bracket (57) with a 3/8” x 2” Bolt (12) and a
3/8” Nylon Locknut (21).
Be sure that the Cable
Trap is inside the Long “U”-Bracket. Note:
This may come pre-assembled.
Route the High Cable (58) between the Cable
Trap (66) and the 3 1/2” Pulley (15) shown in the
inset drawing.
Be sure that the Cable is in the
groove of the Pulley and that the Cable and
Pulley move smoothly.
23. Wrap the High Cable (58) around a 3 1/2” Pulley
(15). Attach the Pulley to the bracket on the Top
Frame (55) with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21).
Be sure that the Cable is in
the groove of the Pulley and that the Cable
and Pulley move smoothly.
24.
Note: This assembly step shows how to com-
plete the assembly of several pre-attached
parts.
The 5/8” x 9/16” Spacer (7) has been pre-
attached on the outside of the 3 1/2” Low Pulley
(76) for shipping purposes. Remove the 3/8”
Nylon Locknut (21), the Spacer, and the Pulley
from the 3/8” x 3 3/4” Bolt (88).
Do not remove
the Bolt. The Bolt has been shown removed
for part identification.
Reattach the 3 1/2” Low Pulley (76) to the 3/8” x
3 3/4” Bolt (88) with the 5/8” x 9/16” Spacer (7)
between the Pulley and the Press Frame (17).
Do
not tighten the 3/8” Nylon Locknut (21) yet.
Be sure that the 3/8” x 3 3/4” Bolt (88), the
3/8” Washer (9), the 5/8” x 9/16” Spacer (7),
the
3 1/2” Low Pulley (76), and the 3/8” Nylon
Locknut (21) are oriented as shown.
22
58
15
15
66
21
12
57
Bracket
55
21
12
15
58
23
24
58
57
21
17
76
7
9
88