Weider WESY96310 - Manual (Page 17)

17
34. See inset drawing A. Attach a 3 1/2” Pulley (15)
and a Cable Trap (66) to the upper hole in a Long
“U”-Bracket (57) with a 3/8” x 2” Bolt (12) and a
3/8” Nylon Locknut (21).
Be sure that the Cable
Trap is inside the Long “U”-Bracket. (Note:
This may come pre-assembled.)
Route the Military Press Cable (72) between the
Cable Trap (66) and the 3 1/2” Pulley (15).
Be
sure that the Cable is in the groove of the
Pulley and that the Cable and Pulley move
smoothly.
See inset drawing B. Slide a 5/16” Washer (8)
onto a 5/16” x 2 3/4 Bolt (11). Insert the Bolt
through the Pivot Arm (101) from the indicated
side. Tighten a 5/16” Nylon Jamnut (93) onto the
Bolt. Slide the end of the Military Press Cable
(72) onto the end of the Bolt. Thread another
5/16” Nylon Jamnut onto the Bolt.
Do not fully
tighten the second Jamnut. There must be
room between the two Jamnuts for the end of
the Cable to pivot.
35. Locate the Leg Press Cable (99). Attach the end
of the Leg Press Cable to the Long “U”-Bracket
(57) with a 1/4” Nylon Locknut (2) and a 1/4”
Washer (10).
Do not completely tighten the
Nylon Locknut; it should be threaded onto the
end of the Cable only a couple of turns, as
shown in the inset drawing.
Wrap the Leg Press Cable (99) around a 3 1/2”
Pulley (15). Attach the Pulley to the Leg Press
Upright (56) with the 3/8” x 3 1/2” Bolt (16), a 3/8”
Flat Washer (9), and a 3/8” Nylon Locknut (21).
The ball on the Cable must be on the indicat-
ed side of the Pulley. Be sure that the Cable is
between the Pulley and the welded rod and
that the Cable and Pulley move smoothly.
34
35
56
Ball
9
21
15
2
10
16
72
15
21
57
A
B
12
101
8
15
66
57
93
2
57
57
99
99
Welded
Rod
72
11