Wolf Appliance Company SO30F/S - Manual (Page 98)

W O L F C O O K T O P V E N T I L A T I O N
98
O V E R A L L D I M E N S I O N S
Downdraft Systems
Models DD30I / DD30R
2 3 / 8 "
(60)
30"
(762)
9 1 / 16 "
(230) 26 1 / 4 "
(667)
1 1 / 2 " (38)
DEPTH OF
DOWNDRAFT CHIMNEY
Models DD36I / DD36R
36"
(914)
32 1 / 4 "
(819)
2 3 / 8 "
(60)
9 1 / 16 "
(230)
1 1 / 2 " (38)
DEPTH OF
DOWNDRAFT CHIMNEY
Specifications on the following pages provide
overall dimensions, blower and ducting consider-
ations, and installation specifics for downdraft
ventilation systems. Also refer to the cooktop
ventilation recommendations on pages 115–116.
If a Model DD30 is installed in combination with
two integrated modules, an integrated module
support for downdraft ventilation is required.
Contact your Wolf dealer for information on
accessory components.
P L A N N I N G I N F O R M A T I O N
Wolf downdraft ventilation systems are available
in 30" (762), 36" (914) and 45" (1143) widths.
The downdraft should be at least as wide as the
cooking surface.
Downdraft Model DD30 will fit most 30" (762)
wide cabinets, Model DD36 will fit most
36" (914) wide cabinets and Model DD45 will fit
most 45 1 / 2 " (1156) wide cabinets. It is recom-
mended that oversized cabinets be used for
easier installation. Cabinet backs may need to be
removed.
IMPORTANT NOTE: To install a downdraft
system and a Wolf cooktop, you must allow for
a minimum 25 1 / 8 " (638) flat counter space from
front to back. A countertop with a raised lip
and/or backsplash may not allow enough space
for proper installation. 2 3 / 8 " (60) of flat counter-
top is required behind the cooktop and 1 3 / 4 " (44)
is necessary between the back edge of the
cooktop and inside of cabinet back.
IMPORTANT NOTE: This appliance must be
used with a Wolf-approved control module and
top cover.
The remote-mounted control module is available
as a sales accessory for Models DD30 and DD36
and is included with Model DD45. Installation of
the control module must be within 10' (3 m) of
the downdraft assembly and a minimum of 4"
(102) from the outer edge of cooktop element or
burner. You will be required to drill three holes
and connect the downdraft to the control
module with the provided wire.
45 1 / 2 "
(1156)
41 1 / 4 "
(1048)
2 3 / 8 "
(60)
9 1 / 16 "
(230)
1 1 / 2 " (38)
DEPTH OF
DOWNDRAFT CHIMNEY
Models DD45I / DD45R
Dimensions in
parentheses are in
millimeters unless
otherwise specified.