Wolf DUAL FUEL RANGES - Manual (Page 12)

12
I
N S T A L L A T I O N
E L E C T R O N I C I G N I T I O N
I N I T I A L L I G H T I N G
Range burners use electronic igniters
in place of standing pilots. When the
range control knob is pushed in and
turned to the "HIGH" position, the
system creates a spark to light the
burner. This sparking continues until
the electronic ignition senses a flame.
• Check operation of the range
burners. Push in and turn each
control knob to "HIGH" position.
The flame should light within four
seconds.
• If burners do not light properly,
turn control knob to the "OFF" posi-
tion. Check that burner head is in the
proper position. Check that the unit is
properly wired to house supply and
that the circuit breaker or house fuse
has not blown. Check that the shut-
off valve is in the "ON" position.
Check operation again. If a burner
does not light at this point, contact
your dealer for assistance.
R E I N S T A L L O V E N
D O O R ( S )
Ovens door(s) have been removed
according to the procedure described
on pages 4-5. Follow these instruc-
tions to reinstall.
Oven Door Reinstallation:
• Grasp the oven door on opposite
sides and lift it until the door hinges
are aligned with the openings in the
oven frame.
• Holding the door at about a 30-
degree angle from the vertical, slide
the hinges into the openings until the
bottom hinge arms drop fully into
the hinge receptacles.
IMPORTANT NOTE: Fully extend
the hinge claw, which is opposite the
hinge pin location, and insert into
hinge pocket prior to inserting oppo-
site side. This will ease installation of
door.
• Lower the door to the fully opened
position. Remove pin from the
appropriate hinge arm.
• Reinstall the plate and screw over
the hinge claw. Refer to the following
illustration.
• Open and close the door com-
pletely to ensure that it is properly
installed.
• For 48-inch and 60-inch units,
complete this procedure for both the
left and right oven doors.
Reinstall Oven Door
PLATE
HINGE
PIN
SCREW