Wolf DUAL FUEL RANGES - Manual (Page 2)

2
I
M P O R T A N T
I
N F O R M A T I O N
IMPORTANT NOTE: This
installation must be completed
by a qualified installer, service
agency or gas supplier.
• INSTALLER: please retain these
instructions for local inspector’s
reference, then leave them with the
homeowner.
• Please read the entire installation
instructions prior to installation.
• HOMEOWNER: please read and
keep these instructions for future
reference.
• Please read the entire Wolf Dual
Fuel Ranges Use & Care Information
book prior to use.
This appliance must be installed in
accordance with all National Electrical
Codes, as well as all state, municipal
and local codes. The correct voltage,
frequency and amperage must be
supplied to the appliance from a
dedicated, grounded circuit that is
protected by a properly sized circuit
breaker or time delay fuse. The
proper voltage, frequency, and
amperage ratings are listed on the
product rating plate.
Record the model and serial numbers
before installing the range. Both
numbers are on the rating plate,
located on the bottom of the control
panel assembly just above the oven
door on the far right.
Model #
Serial #
As you follow these installation
instructions, take particular note of
the CAUTION and WARNING
symbols when they appear. This
information is important for the safe
and efficient installation of Wolf Dual
Fuel Ranges.
In addition, the printed instructions
may signal an IMPORTANT NOTE,
which highlights information that is
especially important for a problem-
free installation.
CAUTION
signals a situation where minor
injury or product damage may
occur if you do not follow
instructions.
WARNING
states a hazard that may cause
serious injury or death if pre-
cautions are not followed.