Wolf DUAL FUEL RANGES - Manual (Page 6)

6
P
R E
- I
N S T A L L A T I O N
Installation Dimensions 30" Range 36" Range 48" Range 60" Range
A Overall width of range (width may vary to + 1 / 8 ") 29 7 / 8 " 35 7 / 8 " 47 7 / 8 " 60 1 / 8 "
B Finished rough opening width 30 " 36 " 48 " 60 1 / 4 "
C Dimension from edge of rough opening 8 1 / 2 " 8 1 / 2 " 24" 31"
D Location of gas supply 10" 15" 10" 10"
E Location of electrical 13" 19" 13" 13"
Note: Dimensions correspond to the illustrations on the following page.
I N S T A L L A T I O N
C O N S I D E R A T I O N S
• Each unit is designed to fit between
cabinets set at the distance specified
by the unit (i.e. a 36-inch unit will fit
a 36" opening). The exception is the
60-inch unit which will require a 60-
1/4" opening.
• Unit is designed with a terminal
block on the rear of the range. The
terminal block will also accept an
appliance power cord. Have a certi-
fied electrical contractor wire your
unit from the junction block to the
terminal block on the range.
NOTE: Refer to the chart below and
the Installation Dimensions illustra-
tions on the following page for exact
rough opening dimensions.
IMPORTANT NOTE: Cabinet
opening dimensions that are shown
must be used. Given dimensions
provide for required clearances.
NOTE: Maintain an 18" (45.7 cm)
minimum clearance from upper
cabinet to countertop, within 6"
(15.2 cm) minimum side clearance
to combustible surface above
countertop.
I S L A N D O R P E N I N S U L A
I N S T A L L A T I O N S
Island Installation: Unit should not
be installed within an enclosure
having an adjacent rear wall that rises
above the cooking surface. Refer to
the chart below and the Installation
Dimensions illustrations on the follow-
ing page.
Peninsula Installation: Unit has a
6-inch minimum clearance to the side
wall, left or right side, and 12-inch
minimum clearance to the rear wall.
NOTE: Refer to the chart below and
the Installation Dimensions illustra-
tions on the following page for exact
rough opening dimensions.
NOTE: Maintain a 30" (76.2 cm)
minimum clearance between top of
cooking surface and bottom of wood
or metal cabinet, which is protected
by not less than 1/4" (.6 cm) flame
retardant millboard covered with not
less than No. 28 MSG sheet steel,
.015" (.04 cm) stainless steel, or
.024" (.06 cm) aluminum or .02" (.05
cm) copper. Maintain a 36" (91.4 cm)
minimum clearance between top of
cooking surface and bottom of an
unprotected wood or metal cabinet.
IMPORTANT NOTE: Locate the
junction box within dimensions
shown, flush with back wall.
• Total rating: 5.2 kW (240V) for
30-inch and 36-inch units, 10.2 kW
(240V) for 48-inch and 60-inch units.
• Total Amps: 22 amps for 30-inch
and 36-inch units, 43 amps for
48-inch and 60-inch units.