Wolfcraft 6155 - Manual (Page 29)

29
WARNING
Operation of Switch Box and
Router
Make sure router switch
is OFF and switch box is
OFF BEFORE proceeding.
1. Insert the yellow safety key into the
switch box.
2. Position router power switch to ON.
NOTE: If your router requires the use of
the switch trigger and "Lock-On" button,
refer to your Router Owner's Manual for
operating instructions.
3. Insert finger under paddle and pull out
switch to ON position.
4. To turn router OFF push paddle in.
Router bit must come to a
complete stop before
leaving router table unattended.
5. Lock switch to OFF position by
removing key from switch box.
For Routers With "LOCK-ON"
Feature
The "LOCK-ON" feature on some
routers will not permit the router to be
turned ON by the switch box, but it can
be turned OFF by the switch box.
1. Place the switch box to ON as
previously described. The router
should NOT start even though the
trigger lock is in the "LOCK-ON"
position. Refer to your router table
Owner's Manual.
WARNING
2. To start router, depress trigger on
router switch and engage "LOCK-ON"
button. Router should start.
NOTE: Typically, a router will not start if
the router switch is already in the
"LOCK-ON" position. In this case,
unlock the trigger, depress the trigger to
start the router, then re-engage the
"LOCK-ON" button.
3. To turn router OFF, push switch
paddle in.
Circuit Breaker
If an overload occurs, the circuit breaker
inside the Switch Box trips and interrupts
power to the router and any accessories.
If this happens:
1. Unplug the power cord.
2. Remove the workpiece from the router
bit and table.
3. Find the cause of the overload and
correct.
4. Push the reset button to reset it. See
Figure 29.
5. Plug in power cord.
6. Follow instructions under Operation of
Switch Box and Router to reset router.
PULL O
N PUSH OFF RESET
OUT LETS
Figure 29
reset button