Wolfcraft 6155 - Manual (Page 31)

31
Do not use a router bit
with a diameter of more
than 2-3/4" on this router table.
Insert Use
1. Select correct insert for the router
bit and your application.
2. To assemble to router table, press
the insert into the hole in the table,
applying pressure to all sides
equally. This assures that insert
snaps into place.
Before removing insert,
switch box must be in
OFF position, router switch must be in
OFF position, and power cord must
be unplugged from outlet.
3. Remove the insert by placing your
finger into the hole in the center.
With light pressure, pull up the
insert.
NOTE: Remove the router bit from the
router before attempting to remove
the insert.
WARNING
WARNING
Figure 31
T
U
V
W
Assemble Inserts
Inserts help reduce the amount of
wood chips and dust that can
accumulate on the router table. They
can also lend stability to the work
piece.
Four inserts come with your router
table. Three of the inserts are for use
with a specific size bit; one can be
custom drilled. Refer to Figure 31 and
to the chart, above right. A center
marking is on the back of the blank
insert for drilling.
Diameter
of Insert
1-1/4"
1-7/8"
2-1/8"
1/4 to 2-3/8"
Diameter of
Router Bit
To Be Used
1-1/8"
1-3/4"
2"
drill out no more
than 2-3/8"
for 2-1/4" bits
Figure 31
Reference
AA
AB
AC
AD