weber 77576 - Manual (Page 20)

20
Operating Instructions
MANUAL LIGHTING
ƽDANGER
Failure to open the lid while igniting the barbecue’s
burners, or not waiting 5 minutes to allow the gas to
clear if the barbecue does not light, may result in an
explosive fl ame-up which can cause serious bodily
injury or death.
1) Open the lid.
2) Make sure all burner control knobs are turned OFF. (Push each knob in
and turn clockwise to ensure they are in the off position.)
ƽ WARNING: The burner control knobs must be in the
OFF position before turning on the liquid propane
cylinder valve. If they are not in the OFF position,
when you turn on the LP cylinder valve, the “excess
gas fl ow control” feature will activate, limiting the
fl ow of gas from the LP cylinder. If this should occur,
turn OFF the LP tank valve and burner control knobs.
Then start over.
ƽDANGER
When the “excess gas fl ow control” feature is
activated, a small amount of gas is still fl owing to the
burners. After turning OFF the cylinder and burner
control knobs, wait at least 5 minutes for the gas to
clear before attempting to light the barbecue. Failure to
do so may result in an explosive fl ame-up, which can
cause serious bodily injury or death.
3) Turn the cylinder on by turning the cylinder valve counterclockwise.
4) Strike a match and put the fl ame into the matchlight hole under the
igniter.
ƽ WARNING: Do not lean over open barbecue when
lighting the barbecue.
5) Select Outside burner, push control knob in and turn to START/HI.
6) Check that the burner is lit by looking down through the cooking grate.
You should see a fl ame
ƽ WARNING: If the burner does not light, turn the
burner control knob to OFF and wait 5 minutes to let
the gas clear before you try again.
7) After the Outside burner is lit you can turn on the Inside burner. The
Inside burner is ignited from the Outside burner.
2). 5).
1).
3).
A. - OFF B. - START/ HI
C. - MED D. - LOW
A D B C
4). 4).
6).
TO EXTINGUISH
Push in and turn each burner control knob clockwise to the OFF position.
Turn gas supply OFF at the source.