Western Telematic CMS-16 - Manual (Page 26)

Note: The Port Password is not displayed by the Port Parameters menu. When the
Port Password has been defined, the field for this item will read "defined". To
display Port Passwords, invoke the /SP or /WP commands as described in
Section 6 .
3. Baud Rate: Selects the baud rate for the port. Can be set to any standard rate from
300 bps to 115.2K bps. (Default = Selected By Option Switches 1, 2, and 3) ●
4. Bits/Parity: (Default = 8-None). ●
5. Stop Bits: (Default = 1). ●
6. Handshake Mode: Selects the handshake format for this port; XON/XOFF, RTS/CTS
(hardware), Both, or None. (Default = RTS/CTS). ●
7. Port Mode: Defines the operation mode for this port. Note that Ports 1 and 2 cannot
be configured for Passive Mode or Buffer Mode. (Default = Any-to-Any Mode).
When Any-to-Any, Passive, or Buffer Mode is selected, the unit will display the DTR
Output prompt as shown in
Figure 5.1 . The DTR Output prompt is not displayed when
Modem Mode is selected.
74. DTR Output: Determines how the DTR line will react when this port
disconnects. The DTR line can be held low, held high, or pulsed for 0.5 seconds and
then held high. In the default state, the DTR line will pulse for 0.5 seconds and then
remain high. For more information on DCD and DTR hardware lines, please refer
to
Appendix A . (Default = Pulse).
❍
PORT PARAMETERS #02
1. Port Name: (undefined)
2. Password: (undefined)
3. Baud Rate: 9600
4. Bits/Parity: 8-None
5. Stop Bits: 1
6. Handshake Mode: CTS/RTS
7. Port Mode: Modem
71. Reset String: ATZ
72. Init String: AT&C1&D2S0=1
73. Hang-Up String: (undefined)
8. Supervisor Mode: Permit
9. Logoff Character: +
10. Sequence Disconnect: Three Characters
11. Timeout Disconnect: Off
12. Response Type: Verbose
13. Command Echo: On
14. Accept Break: Yes
●