Western Telematic CMS-16 - Manual (Page 30)

disconnect from a second port (Resident Disconnect). When defining the Logofff
Character, note the following:
The default Logoff Character is " +". As a result, the default Resident Disconnect
Sequence is [Enter] +++[Enter].
●
The default three character Resident Disconnect Sequence uses the format
[Enter]
LLL[Enter], where L is the Logoff Character. If the one character
disconnect is selected (see item 14), a resident connection is terminated by simply
typing the Logoff Character once (without carriage returns)
●
Sequence Disconnect: Enables/Disables and configures the Resident Disconnect
command. This prompt offers the option to either disable the Sequence Disconnect, select
a three character format, or a one character format. (Default = Three Characters). Note the
following:
When a Resident Connection is initiated, the CMS will send a message which lists
connected ports, and displays the one character or three character disconnect
command that will be required in order to terminate the connection. ●
The One Character Disconnect is intended for situations where the destination port
should not receive the disconnect command. When the Three Character format is
selected, the disconnect sequence will pass through to the destination port prior to
breaking the connection. ●
When Three Character format is selected, the Resident Disconnect uses the format
"[Enter]
LLL[Enter]", where L is the selected Logoff Character.
●
When the One Character format is selected, resident connections are terminated by
entering the selected Logoff Character only. There is no need to press [Enter]
before and after the Logoff Character when the One Character format is selected. ●
14.
Timeout Disconnect: Enables and selects the Timeout Disconnect for the Network Port.
If enabled, and the port does not receive or transmit data for the specified time period, the
port will disconnect. (Default = 5 Minutes). 15.
Response Type: Selects the type of messages that the port will send in response to
commands. The user can select Verbose (English Text), Terse (Numeric / Abbreviation),
or Quiet Mode (No Response). (Default = Verbose). 16.
Command Echo: Enables or Disables the command echo for the Network Port. (Default
= On). 17.