Western Telematic CMS-16 - Manual (Page 55)

Resident Disconnect Sequence or wait for the Timeout Period to elapse (if enabled).
Availability: Supervisor Only
Format:
/D[/Y] <x> [x] [Enter]
Where:
/Y (Optional) suppresses the "Sure?" prompt.
x Is the number or name of the port(s) to be disconnected. To Disconnect all ports, enter an
asterisk. To disconnect the Network Port, enter an " N".
Response:
Verbose: "Are you Sure (y/n)?", if Y, unit will respond with "Disconnected".
Terse: 5, if Y, unit will respond with 3.
Example: To disconnect Port 2 from Port 3 without the "Sure?" prompt, access the Command
Mode from a third port with "All" command capability and type one of the following commands:
/D/Y 2 [Enter] or /D/Y 3 [Enter]
/E Erase Buffer
Erases data from the buffer for a specified port or several ports. Note that erased data cannot be
recovered.
Availability: Supervisor Only
Format:
/E[/Y] <x> [x] [Enter]
Where:
x Is the number or name of the port buffer(s) to be cleared. To erase buffers for all ports,
enter an asterisk.
/Y (Optional) Suppresses the "SURE? (Y/N)" prompt.
Response:
Verbose: "Are You Sure (y/n)?", if Y, the unit will respond with "OK".
Terse: 5, if Y, the unit will respond with 0.
Example: To clear the buffer for Port 3, access the Command Mode from a port with "All"
command capability, and type
/E 3 [Enter].
/F Set System Parameters
Displays a menu which is used to define the Site ID message and Supervisor Password. When
the Supervisor Password is defined, the CMS will display a password prompt before allowing