Western Telematic CMS-16 User Manual
Page 52
Display Port Status
/S[P] [Enter]
X (1) (2)
X (1)
Display Port Diagnostics
/SD [Enter]
X (1)
X (1)
Display Network Status
/SN [Enter]
X
Display Port
Parameters (Who)
/W[P] [n] [Enter]
X (2)
X (3)
Set System Parameters
/F [Enter]
X
Set Network Port Parameters /N [Enter]
X
Set RS232 Port
Parameters
/P <x> [Enter]
X
Copy RS232 Port Parameters /CP [Enter]
X
Connect
/C <x> [x] [Enter]
X
X (4)
Resident
Disconnect (5)
[Enter]+++[Enter]
X
X
Third Party
Disconnect (6)
/D[/Y] <x> [x] [Enter]
/D[/Y] * [Enter]
X
Erase Buffer
/E[/Y] <x> [x] [Enter]
/E[/Y] * [Enter]
X
Reset Network Port
/T [Enter]
X
Default & Test
/I[/Y] [Enter]
X
Save Parameters
/U [Enter]
X
Upgrade Firmware
/UF [Enter]
X
(1) Supervisor Mode displays parameters for all ports;
User Mode only displays parameters for the ports allowed by the Port
Password.
(2) To display Port Passwords, include the "P" Option. (Supervisor Only).
(3) A port with "User" command capability can only view its own
parameters. A User Port cannot view parameters for other ports.
(4) A User Port cannot perform a Third Party Connect.
(5) Resident Disconnect: Disconnects your resident port from another
port. Note that the Resident Disconnect Sequence can be redefined via
the Port Configuration Menus.
(6) Third Party Disconnect: Disconnects two or more nonresident ports.
Must be issued from a third port with Supervisor command capability.