Western Telematic APS-8M - Manual (Page 44)

7-4
APS-8M Asynchronous Port Switch; User’s Guide
7.3. The Port Parameters Screens (/W)
The /W command displays more detailed information about an individual APS
port. Rather than listing connection information for all ports like the Port
Status Screens, the Port Parameters screen lists all defined parameters for a
specific port as shown in Figure 7.3.
The /W command is available to both Supervisor Mode and Non-Supervisor
Mode ports and passwords. Note however, that if the /W command is invoked
by a port or password that does not permit access to Supervisor Mode, then the
APS will only display information for your resident port.
7.4. The Password Directory Screen (/V)
The Password Directory Screen (Figure 7.4) lists currently defined parameters
for each of the APS-8M passwords. Note that the Password Directory screen
will not display actual passwords, and instead, will only indicate whether or
not a password has been defined for each username.
The Password Directory Screen is only available when the Supervisor Mode
is active, and cannot be displayed by ports or passwords that do not permit
Supervisor Access. The APS-8M allows for the definition of up to 32 separate
passwords.
PORT PARAMETERS #01:
1. Port Name: (undefined)
2. Baud Rate: 9600
3. Bits/Parity: 8-None
4. Stop Bits: 1
5. Handshake Mode: RTS/CTS
6. Port Mode: Any-to-Any
64. DTR Output: Pulse
7. Supervisor Mode: Permit
8. Logoff Character: ^X
9. Sequence Disconnect: One Character Only
10. Timeout Disconnect: Off
11. Response Type: Verbose
12. Command Echo: On
13. Accept Break: Yes
14. Invalid Access Lockout: Off
APS>
Figure 7.3: The Port Parameters Screen (Port 1 Shown)